Technical information

Enrange CAN-2 Instruction Manual
January 2014
Page 22 of 33
programming of the device. The third tab is the FDP tab which is used to program new firmware
into the device. For more information on the Programming and FDP tabs, please refer to the
RCP User Guide.
Unit Info Tab
This page allows the user to view the receiver Project ID and serial number. The user can modify
the receiver name, access code, RF channel, receiver timeout, and whether to use an internal or
external RF antenna. CAN bus properties are able to be set in this page as well.
NOTE: Changing any of these details will require a reboot of the CAN-2 after the new information
has been sent to the device.
The Unit Info page is divided into three sections. The leftmost section is the Unit Info Properties
grid. The middle section, which is the Device Block Diagram, shows the pinout of the unit and
each pin’s function. Clicking on a pin or function will show any configurable properties in the Pin
Properties Grid, which is the rightmost section. Each of these sections is described in greater
detail on the next page.