Technical information

Enrange CAN-2 Instruction Manual
January 2014
Page 21 of 33
WARNING
IF THE “RECEIVE DEVICE DATA” CHECK BOX IS UNCHECKED, THE RCP PROGRAM WILL
OVERWRITE ALL SETTING VALUES ON THE DEVICE WITH DEFAULT VALUES AND ANY SETTINGS
CHANGED BY THE OPERATOR UPON SENDING THE PROGRAM TO THE DEVICE. ALL STORED
VALUE SETTINGS WITHIN THE DEVICE WILL BE REPLACED, INCLUDING ANY PROJECT-SPECIFIC
VALUES. MAGNETEK STRONGLY RECOMMENDS THAT THE “RECEIVE DEVICE DATA” CHECK BOX
BE LEFT CHECKED.
This screen also allows the programmer to create a specific name for the device to help keep
track of device settings and changes. It is recommended that a unique name is chosen for each
device programmed with RCP.
5.4.1 CAN-2 Configuration Tabs
The CAN-2 Receiver has up to three configuration tabs that are used to configure and program
the device. The first tab is the Unit Info tab which permits configuration of general settings as well
as the CAN port configuration. The second tab is the Programming tab which permits custom