Technical information

Enrange CAN-2 Instruction Manual
January 2014
Page 18 of 33
WARNING
THE ACCESS CODES IN THE RECEIVER ARE UNIQUE AND FACTORY PRESET. DO NOT CHANGE
THESE ACCESS CODES UNLESS YOU ARE REPLACING AN EXISTING RECEIVER AND ITS ACCESS
CODE. CHANGING THIS CODE COULD MAKE IT COMMON WITH ANOTHER RECEIVER ACCESS
CODE, WHICH COULD MOVE OTHER EQUIPMENT. NO TWO SYSTEMS IN ANY LOCATION SHOULD
EVER HAVE THE SAME ACCESS CODES INDEPENDENT OF THE FREQUENCY. FAILURE TO
FOLLOW THIS WARNING COULD RESULT IN SERIOUS INJURY OR DEATH, AND DAMAGE TO
EQUIPMENT.
5.3 CONNECTING THE CAN-2 TO A COMPUTER
The CAN-2 receiver contains circuits that permit communication with a computer system via USB.
If the CAN-2 receiver was ordered with the Pre-Wired Cable kit, the 195-50539 USB cable can be
added by simply plugging in the connector. This option provides a USB-mini B plug for
connection to a computer system.
If not using the CAN-2 Pre-Wired Cable Kit, the CAN-2 can be wired for USB connection using
the pin outs in the figure below.
Figure 12: USB Connection Wiring
When plugging in a CAN-2 receiver to a computer system, it is strongly recommended that a USB
isolation hub, like Magnetek part 195-50645, is used between the CAN-2 and the computer
system.