Technical information

Enrange CAN-6 Instruction Manual

September 2011

age 2 of 24

TABLE OF CONTENTS

1.0 INTRODUCTION .................................................................................................................. 3

1.1 PRODUCT MANUAL SAFETY INFORMATION ............................................................... 3

1.2 WARNINGS and CAUTIONS ............................................................................................ 4

2.0 CRITICAL INSTALLATION CONSIDERATIONS ................................................................. 5

2.1 GENERAL ......................................................................................................................... 5

2.2 PERSONS AUTHORIZED TO OPERATE RADIO CONTROLLED EQUIPMENT ........... 5

2.3 SAFETY INFORMATION & RECOMMENDED TRAINING FOR RADIO CONTROLLED

EQUIPMENT OPERATORS ........................................................................................................ 6

2.4 PRE-OPERATION TEST .................................................................................................. 7

3.0 CAN-6 RECEIVER INSTALLATION ..................................................................................... 8

3.1 PRE INSTALLATION ........................................................................................................ 8

3.2 MECHANICAL DRAWINGS .............................................................................................. 8

3.3 INSTALLATION ............................................................................................................... 10

3.4 REMOVAL OF CAN-6 FROM HOUSING ....................................................................... 10

3.5 PIN OUT DIAGRAM AND DEFINITIONS ....................................................................... 11

3.6 CAN-6 RECEIVER BLOCK DIAGRAM ........................................................................... 13

4.0 CONFIGURING THE CAN-6 .............................................................................................. 14

4.1 SETTING ANTENNA TYPE ............................................................................................ 14

4.2 REMAINING BANK 1 DIP SWITCH SETTINGS............................................................. 14

4.3 RECEIVER CHANNEL CONFIGURATION SETTINGS (DIP SWITCH BANK 2) .......... 15

4.3.1 Channel Dip Switch Settings for 900MHz Part 15 ................................................... 16

4.3.2 Channel Dip Switch Settings for 433MHz Part 15 ................................................... 17

4.3.3 Channel Dip Switch Settings for 2.4GHz @ 50mW and 125mW ............................ 18

4.4 FCC STATEMENTS ........................................................................................................ 19

5.0 NORMAL OPERATION ...................................................................................................... 20

5.1 INITIALIZATION .............................................................................................................. 20

5.2 NORMAL OPERATION ................................................................................................... 20

5.3 LED STATUS INDICATION ............................................................................................ 20

5.3.1 RF Messages LED (Top LED on CAN-6 Faceplate) ............................................... 20

5.3.2 Signal Strength/Error Code LED (Bottom LED on CAN-6 Faceplate) ..................... 21

6.0 TROUBLESHOOTING ........................................................................................................ 22

6.1 TROUBLESHOOTING TABLE ....................................................................................... 22

6.2 ASSEMBLY AND REPLACEMENT PARTS ................................................................... 24