Technical information

Enrange CAN-6 Instruction Manual
September 2011
Page 23 of 24
CAN messages
transmitted by
the receiver are
not being
received
Incorrect source address
Make sure that the source address of the
receiver is set correctly.
The termination resistor is
set incorrectly
Ensure the termination resistor is
appropriately set.
Incorrect baud rate
Ensure the correct baud rate is set by all
devices on the bus.
Outputs not
functioning
Faulty Wiring
Check all wires for loose or damaged
connections.
Output is shorted or opened
Check all wires and connections for
damaged insulation.
Table 1: Troubleshooting Table