Installation guide

280 Debug Environment
12.1 - Setting Project Debugging
To set the debug mode click on the
Compile
menu
and then on the
Debug mode
item. The project must
be compiled and downloaded before task debugging
can begin. To cancel the debugging mode selection
click on the
Compile
menu and then the
Release
mode
item. To complete this cancellation the proj-
ect must now be compiled and downloaded
.
12.2 - Task Debugging
A project that is loaded into the controller can be
debugged if the project has been compiled in Debug
mode and downloaded. The project to be debugged
must be open. To enter the debug environment click
on the
Debug
command button. This environment
consist of an
Exit
command button,
Step
command
button,
Halt
command button,
Break
command
button,
List Breakpoints
command button,
Instant
Watch
command button,
Run
command button,
Toggle breakpoints
command button,
Watch
command button,
Update Watch
command button,
program status indicator,
Terminal
window,
Watch
window and
Program
window.
Watch Window
Program status
STOPPED
Instant watch
U pdate watch
List Breakpoints
W atchT oggle breakpoints
B reakH altS tepE xit
R un
Status Indicator
Terminal Window
Command Buttons
Program Window
Compile
C
ompile project
R
elease mode
D
ebug mode