Installation guide

Following for MX2000 version 4.0 233
FOLMINRATIO Following Parameter
ACTION: Sets or returns the minimum allowable following axis speed during
a recede offset cycle.
PROGRAM SYNTAX: FOLMINRATIO(axis)=expression
FOLMINRATIO=expression1 , ... , expression8
FOLMINRATIO(axis, ... ,axis)=expression, ... , expression
FOLMINRATIO(axis) - used in an expression
REMARKS: The expression sets the minimum speed ratio to the master. This
value must be less than the FOLRATIO of the axis and can be a
negative value.
If the value is a negative number the following axis will be allowed
to reverse the direction during a recede offset cycle.
The axis specifies the number of the following axis (1-8).
EXAMPLES: x=FOLMINRATIO(axis)
Sets the expression to the current FOLMINRATIO of the specified
axis.
FOLMINRATIO(2)= -2.0
sets the following minimum speed for axis 2 to -200% which
allows an offset recede cycle to reverse directions.
FOLMINRATIO=.1,,0
sets the folminratio of axis 1 to 10% of master and folminratio of
axis 3 to 0% of the master.
FOLMINRATIO(1,3)=.1,0
sets the folminratio of axis 1 to 10% of master and folminratio of
axis 3 to 0% of the master.
Master Velocity
100%
FOLMINRATIO
0%
FOLSYNCDIST
FOLOFFSETDIST
FOLLOWING OFFSET
RECEDE CYCLE