Installation guide

232 Following for MX2000 version 4.0
FOLMAXRATIO Following Parameter
ACTION: Sets or returns the maximum allowable following axis speed
during an offset advance cycle.
PROGRAM SYNTAX: FOLMAXRATIO(axis)=expression
FOLMAXRATIO=expression1 , ... , expression8
FOLMAXRATIO(axis, ... ,axis)=expression, ... , expression
FOLMAXRATIO(axis) - used in an expression
REMARKS: The expression sets the maximum speed ratio to the master. This
value must be larger than the FOLRATIO of the axis. The value
must be a positive number.
The axis specifies the number of the following axis (1-8).
EXAMPLES: FOLMAXRATIO(2) = 3
sets the folmaxspeed of axis 2 to 300% of the master.
FOLMAXRATIO=.5,,1
sets the folmaxratio of axis 1 to 50% of master and folmaxratio of
axis 3 to 100% of the master.
FOLMAXRATIO(1,3)=.5,1
sets the folmaxratio of axis 1 to 50% of master and folmaxratio of
axis 3 to 100% of the master.
Master Velocity
100%
FOLMAXRATIO
200%
FOLSYNCDIST
FOLOFFSETDIST
FOLLOWING OFFSET
ADVANCE CYCLE