Installation guide

Programming Commands 105
FOLRATIO Following Parameter
ACTION: Sets the ratio of the following axis to the master. A value of 1 represents
100% of the master.
PROGRAM SYNTAX: FOLRATIO(axis)=expression
FOLRATIO=expression1, ... , expression8
FOLRATIO(axis, ... ,axis)=expression, ... , expression
FOLRATIO(axis) - used in an expression
REMARKS: This command is defined in more detail in Section 8 Following.
FOLRATIOINC Following Parameter
ACTION: Specifies the acceleration rate for a folratio change during motion in ra-
tio increment per second.
PROGRAM SYNTAX: FOLRATIOINC(axis)=expression
FOLRATIOINC=expression1, ... , expression8
FOLRATIOINC(axis, ... , axis)=expression, ... , expression
FOLRATIOINC(axis) - used in an expression
REMARKS: This command is defined in more detail in Section 8 Following.
FOLSTARTDIST Following Parameter
ACTION: Specifies a master distance which is used as a delay distance for starting
motion. The distance delay starts when the specified starting trigger of a
FOLTRIG command occurs.
PROGRAM SYNTAX: FOLSTARTDIST(axis)=expression
FOLSTARTDIST=expression1, ... , expression8
FOLSTARTDIST(axis) - used in an expression
FOLSTARTDIST(axis, ... .axis)=expression, ... , expression
REMARKS: This command is defined in more detail in Section 8 Following.