Installation guide

Programming Commands 103
FOLMAXRATIO Following Parameter
ACTION: Sets or returns the maximum allowable following axis speed during an
offset advance cycle.
PROGRAM SYNTAX: FOLMAXRATIO(axis)=expression
FOLMAXRATIO=expression1 , ... , expression8
FOLMAXRATIO(axis, ... ,axis)=expression, ... , expression
FOLMAXRATIO(axis) - used in an expression
REMARKS: This command is defined in more detail in Section 8 Following.
FOLMINRATIO Following Parameter
ACTION: Sets or returns the minimum allowable following axis speed during a re-
cede offset cycle.
PROGRAM SYNTAX: FOLMINRATIO(axis)=expression
FOLMINRATIO=expression1 , ... , expression8
FOLMINRATIO(axis, ... ,axis)=expression, ... , expression
FOLMINRATIO(axis) - used in an expression
REMARKS: This command is defined in more detail in Section 8 Following.
FOLMOVE Following Parameter
ACTION: Request a Following axis move.
PROGRAM SYNTAX: FOLMOVE(axis)=expression
FOLMOVE=expression1 , ... , expression8
FOLMOVE(axis, ... , axis)=expression, ... ,expression
REMARKS: This command is defined in more detail in Section 8 Following.