Installation guide

Page I-41
Installation and Setup
Installing The Receiver
STEP 4: INSTALLING THE RECEIVER
Connect the output of the satellite receiver to your TV as described in the Bell ExpressVu
User Manual, and turn on the Bell ExpressVu receiver. Use your new remote control to
carry out the following steps (the remote control operation is fully described in the User
Manual). Note that the Bell ExpressVu receivers are configured at the factory for English
language operation. French language operation is available after the dish is aligned and
the initial software download is complete.
See “Wiring Setups” in the Bell ExpressVu User Manual for suggested wiring
configurations.
4100_Ins_eng 6/16/05 12:34 PM Page 45