Installation guide

You will also need some tools:
A 7/16”,1/2”, 9/16” wrench (varies with dish size)
A Phillips screwdriver
A spirit level
A drill and drill bits (masonry and wood)
A 3/8” masonry drill bit for the concrete anchors
INSTALL BATTERIES IN THE REMOTE
The remote is shipped with four AAA batteries, packaged separately.
1. Press down on the slot in the battery case cover
(on the back of the remote) to open the cover.
2. If you are replacing old batteries, remove all
four batteries.
3. Insert the new batteries, being sure to match the
plus (“+”) ends with the plus indicators on the
remote. The batteries alternate plus and minus
(“-”) ends when properly seated.
4. Replace the cover by inserting the tabs into the
slots, and snapping the cover into place.
If the remote does not work after installing the batteries, confirm that the batteries are
properly seated, with the plus and minus ends aligned correctly.
SET THE REMOTE ADDRESS
When you get your receiver and remote, they are set to address 1. Unless you experience
problems, you do not need to change the address at this time. If you want to change the
address, see “Set the Remote Address” on page I-60.
You may need to set the remote address in any of the following situations:
• There is another Bell ExpressVu receiver and remote being used in the vicinity.
Note: You may need to assign an address to your remote and receiver, so that the
receiver responds only to that remote.
• If your receiver and remote addresses do not match, you must match them to be able to
use the remote. See "Set the Remote Address" on page I-7.
Page I-7
Installation and Setup
Before You Start Installation
4100_Ins_eng 6/16/05 12:34 PM Page 11