Manual

_iur TV remote can be set to work various
xternal devices such as VCRs, Cable
Boxes, Satellite Receivers, DBS, DVD
Players, etc., by using the search method of
remote contlvl programming.
If the Code Entl 7 method shown on the p_'vi-
ous page did not set your _,mote to work your
external device, then follow the easy steps
listed below.
Please read steps 1-4 before beginning.
Press the POWER button on the
accessory device to turn it ON.
Place the TV/VCR/ACC Mode
Switch in the proper position for the
device you wtmt to operate.
Press and hold the A/CH • RECORD
and SMART SOUND buttons simul-
taneously.
The device will begin to chtmge chtm-
nels after the remote identifies the cor-
rect code. When the channels start to
change, release the A/CH •
RECORD and SMART SOUND but-
tons. The remote should be ready to
operate the device.
Satellite Receiver
VCR
HELPFUL HINT
This method ctu] take up to two minutes to
_erform.
Don't let the device sctm up morn than five
channels. If you do, the remote may pass up
the right code and another two minute
search cycle will have to be repeated.
If no channel change happens within two
minutes, repeat steps 1-4. Should a channel
change still not occur, the remote will not
work the desired device.
J
NOTE: The remote is for use with exter-
nal accessory devices only and not for
use w th other brands of TVs.
32