Manual

k...d_
.#cer your personal Censor
ode number has been set (see
previous page), you are now ready
to select the channels you want to
censor or block out.
Fa-ggral
_> Select the CENSOR
VIEWING control.
With the ADVA.NCED
CONTROLS on screen, press the
MENU ,IkY buttons to move the
red arrow. Then press MENU
button.
"ENTER CURRENT CODE"
shows on Ll'lescreen.
_',_ Enter the correct Censor Code
I number.
_.'-_> Press Channel AY or Channel
Number buttons to select the
channel to be censored.
_ Press the (+) button to "BLOCK
VIEWING" on the selected
channel.
Press the (-) button to "ALLOW
VIEWING" on a blocked channel.
Repeat steps 4 and 5 for any other
channels you wish to block out.
"--_ Remember. You can also
l]l_?block out the use of the
Audio/Video Input jacks on the
TV. This stops the viewing of VCR
programs which can be shown
through the A/V IN jacks. Just
select VCR/AUX1 or AUX2
(located between the lowest and
highest channel numbers) on the
Censor Viewing screen, and select
Block Viewing.
Note: To make TV viewing easier
all channels (and Audio/Video
Input jacks) will be unblocked,
once the correct Censor Code
number has been entered for one
blocked out channel.
When the TV is turned OFF and
then back ON again, Censor
Viewing is back in place for all
channels.
ADVANCEDCONTROLS
ADD/DELETECHANNELS
REDCONVERGENCE
BLUECONVERGENCE
-- TV SPEAKERSON]OFF
I_ CENSORVIEWING
I CHANGECENSOR CODE
EXIT
i!i::!
33