Technical data

Table 3-2. Wipe Solvents - Continued
Solvent Selection
Metals
Organic Coatings FL 6
Coated Solvent Resistant Finishes FL 6
Composite Materials
Reactivation of Painted Surface
Regulated By NESHAP FL 1
Meets Requirements of NESHAP FL 2
NESHAP Exempt FL 3
Surface to be Cleaned Compliance
A-A-2904, Mineral Spirits G G G X FL 5
Ketones
Acetone GF GF GF X X
Methyl Ethyl Ketone (MEK) FFFFXX
Methyl Propyl Ketone (MPK) GF GF GF X X #
Specialty Solvents
Parachlorobenzotrifluoride (PCBTF) G G G X X
Solvent Blends
MIL-T-81772, Type II GF X
1:1 MEK Toluene FFFFXX
1:1 MEK Acetone GF GF GF X X #
1:1 MPK Naptha GGGG X#
1:1 Acetone: PCBTF GF GF GF X X
A-A-59231 F X
DS-104, Dynamold Solvents, Inc GF GF GF GF X *
DS-108, Dynamold Solvents, Inc GF GF GF GF X *
SD 1291, Brulin Corp. G G G X *
Super 140, LPS Industries G G G X *
Terpenes
Citra Safe, Inland Technology GF GF GF X *
De-Solv-It , Orange-Sol, Inc. G G G X *
G = Use for General Cleaning in surface preparation for painting (General cleaners not approved for Final Clean-
ing leave a residue and must be followed by Final Cleaning before painting.)
F = Use for Final Cleaning before paint.
FL 1 = If the requirements of the National Emission Standards for Hazardous Air Pollutants (NESHAP) must be
complied with, these solvents maybe restricted from use or have very specific limitations applied to their use.
FL 2 = These solvents meet the requirements of the NESHAP for compliance. This only applies where the re-
quirements of the NESHAP are being enforced.
# = These solvents have a vapor pressure not exceeding 45 mm Hg (24.1 in H2
O
) at 20° C (68° F) and will have
reporting and other requirements under the NESHAP.
TO 1-1-8
3-6