Technical data

SAFETY SUMMARY
1 GENERAL SAFETY INSTRUCTIONS.
This manual describes physical and chemical processes,
which may cause injury or death to personnel, or damage to
equipment if not properly followed. This safety summary
includes general safety precautions and instructions that must
be understood and applied during operation and maintenance
to ensure personnel safety and protection of equipment. Prior
to performing any task, the WARNINGs, CAUTIONs, and
NOTEs included in the task shall be reviewed and under-
stood.
2 WARNINGS, CAUTIONS, AND NOTES.
WARNING, CAUTION, and NOTE statements have been
strategically placed throughout this text prior to operating or
maintenance procedures, practices or conditions considered
essential to the protection of personnel (WARNING) or
equipment and property (CAUTION), or when essential to
highlight a practice (NOTE). A WARNING, CAUTION or
NOTE will apply each time the step to which it refers is
repeated. Prior to starting any task, the WARNINGS, CAU-
TIONS, and NOTES for that task will be reviewed and
understood. Refer to the materials list table at the beginning
of the appropriate work package for material used during
maintenance of this equipment. The detailed warnings for
hazardous materials are listed separately in the safety sum-
mary in the Hazardous Materials paragraph. Other warnings,
cautions, and notes which appear in this manual are not listed
separately in this safety summary, and are defined as follows:
Highlights an essential operating or maintenance
procedure, practice, condition, statement, etc.,
which, if not strictly observed, could result in
injury to, or death of, personnel or long term
health hazards.
Highlights an essential operating or maintenance
procedure, practice, condition, statement, etc.
which if not strictly observed, could result in
damage to, or destruction of, equipment or loss of
mission effectiveness.
NOTE
Highlights an essential operating or maintenance
procedure, condition, or statement.
3 HAZARDOUS MATERIALS WARNINGS.
Hazardous Material Warnings are provided through use of
Hazard Symbols listed below. Consult the HAZARDOUS
MATERIALS DESCRIPTION below or MSDS OSHA Form
20 or equivalent for specific information on hazards, effects
and protective equipment requirements. If you do not have an
MSDS for the material involved, contact your supervisor, or
base Safety or Bioenvironmental Engineering Offices.
TO 1-1-8
xi/(xii blank)