Owner`s manual

38 EN38 EN
DUBBING MODE
1
Press [SETUP] and use [K / L] to
select “General Setting”, then press
[OK].
“General Setting” menu will appear.
2
Use [K / L] to select “Recording”,
then press [OK].
“Recording” menu will appear.
3
Use [K / L] to select “Dubbing
Mode”, then press [OK].
Selection menu will appear.
You can copy a DVD to a cassette tape or copy a cassette
tape to a DVD. This function will be possible only if the
DVD or the cassette tape is not copy protected.
Before starting this function, prepare for the recording on the
DVD+RW/+R, DVD-RW/-R or the cassette tape. Refer to pages
22 and 77.
Make sure:
• Insert a recordable disc and a cassette tape with a erase-
protection tab.
Note for recording to a cassette tape:
• The cassette tape's erase-protection tab is intact.
• The remaining time of the cassette tape is long enough.
Note for recording to a disc:
• Make sure that the disc is recordable. Refer to page 21.
Note for VCR to DVD duplication
• After starting VCR to DVD duplication, the picture
may be distorted because of the auto tracking
function.
This is not a malfunction. Be advised to playback the
cassette tape until the picture is stabilized, then set
the starting point which you wish to start recording,
and start VCR to DVD duplication.
STANDBY-ON
TIMER SET
ABC DEF.@/:
JKL MNOGHI
TUV WXYZ
SPACETIMER CLEAR
SETUPDISC MENU
RETURNTITLE
TRACKING
VCR DVD
AUDIOREC
REC MODE D.DUBBING
CM SKIP SEARCH RAPID PLAY
PQRS
SOURCE
123
456
78
0
OK
+--
o
p
B
B
iji
C F gh
s
9
DISPLAY OPEN/CLOSE
A
I
SETUP
p
o
OK
B
F
REC MODE
VCR
D.DUBBING
DVD
E9E2ZUD_BZV420MW8.indd 38E9E2ZUD_BZV420MW8.indd 38 2007/09/04 17:05:542007/09/04 17:05:54