Manual
J
See the above information on
how to use the Locator Code
Button for Programming.
<.
For most homes this step wouM
not be needed but for your
infl_rmatio n :
Up to 9 different remote locator
address codes can be set on which the
TV can send out its "homing" signal
This is done in case there is more than
one TV (with a remote locator)
_reser, t, and you want only one
specific remote to be signaled when the
TV is turned ON.*
To set a Locator Address Code:
>With TV turned ON, press the
LOCATOR CODE button on the
ren_ote. (Also be sure the TV
SY_TEM button on the remote has
been lZressed.)
You will need a pencil or pen to press
the recessed button.
The: TV shows the present Remote
Lo_ator Code.
,_ Press any (0-9) on
number button
the remote to set or change the Locator
Code.
The remote will beep t_3let you know
it has received the new Locator Code
and th_n return to its normal operating
mode.
Remember, if batteries are
replaced the Locator Code
will need to be reentered.
Whe:a setting the Locator Code if any
butten, other than the number buttons,
are pressed the remote will return to
its normal operation mode.
*For owners who liw: in an apartment
(townhouse or condominium)
complex, this task may be necessary
since the remote loca_:or's signal can
be sent and detected directly through
adjoining walls.
33