User manual
Symptoms Items to Check and Actions to follow
"Ghost" or double • This may be caused by obstruction to the antenna due to high rise buildings or hills.
images Using a highly directional antenna may improve the picture.
No power • Check that the TV's AC power cord is plugged into the mains socket.
• Unplug the television, wait for 60 seconds. Then re-insert plug into the mains socket
and turn on the television again.
No picture
No picture and power
switched on
Picture position
adjustment
• Check antenna connections at the bottom of the TV to see if they are properly connected to the TV.
• Possible broadcast station trouble. Try another channel.
• Adjust the contrast and brightness settings. Try another auto picture setting.
• Check the Closed Captions control. Some TEXT modes could block the screen.
• Check if you selected the correct AV source.
• Your TV has a protective mode in case there is too much heat build-up. Check the
clearance around the vents of the device to be certain there are no blocking walls or
cabinets which would limit the air flow.
When displaying a High Definition signal from the YPbPr inputs or HDMI input, if necessary, you can
adjust the picture position to the center of the screen with the cursor left/right or up/down buttons on
the remote control. This may be needed due to slight differences in output signals from different brands
and types of HD sources boxes.
Notes: Most High Definition receiver boxes also have pictureopositioning controls in their menu
systemsuIf the TV cursor controls run out of range befbre the picture is correctly positoned, the
receiver box controls will need to be adjustedu
No photo, music or ° Check if the source complies with a supported code.
video play or in poor
quality only
No sound • Increase the VOLUME.
• Check that the TV is not muted, press the MUTE button on the remote control.
• When no signal is detected, the TV automatically switches offthe sound. This is proper
operation and does not indicate a malfunction.
• Adjust the contrast, color, tint and brightness setting. Try another auto picture setting.
• Check the antenna connection.
Good sound but poor
color or no picture
Snowish picture and
noise
Television not
responding to
remote control
• Check whether the batteries are working. Replace if necessary.
• Clean the remote control sensor lens on the monitor.
• Operating range between TV and the remote control should not be more than approximately twenty feet.
• You can still use the buttons on the right side of your TV.
• Check if the remote control is in the correct mode.
Control of accessory • The infrared signals of the screen may influence the reception sensibility of other peripherals Solution:
devices replace the batteries of the remote control of other devices. E.g. keep away a wireless headphone from
within a radius of approximately four feet.
The software will not Possibly the operating system is wrong.
install Go to www.usasupport.magnavox.com to see which operating systems are supported.
Standby
After improper
shutdown
Miscellaneous
I
Your TV consumes energy less than Iw in the standby mode. ]
If your TV has been shutdown in an improper way (e.g. power drop, power cord plug out), starting up the
TV again will take a longer time than usual.
See Extras, Specifications on this user's manual.
34