User guide

134
ENGLISH
Granular Switchbox
1— Manifold mount for EXR IV Hydraulic
Control Valves.
ee—Use with 105-0104 Driver Module only.
mm—Use with 105-0105 Driver Module only.
aa— Requires a metal object (i.e., Sprocket Teeth)
from which to read pulses. Contact TeeJet.
cc— Does not require an Adapter Cable when used with
404-0061 or 404-0047.
dd— Use with 405-0098 or with Standard Flow Control Cable
404-0022, or with 405-0074 and 405-0174 Power and
Flow Control Harnesses.
ff—Requires 45-06114 or 45-05141 Cable.
w—Incorporates Boom Status Cable
x— Use 402-0040 or 402-0065 to adapt DICKEY-john 360
Slot Sensor to this box.
y—Use in conjunction with Boom Status Cable.
z—Requires special cables. Refer to the Air-Max system.
Switchboxes
Single-boom or dual-boom switchboxes incorporate Off,
Auto (On) and Ground Speed Override (GSO) functions into a
single unit. Boom sense cables are available for vehicles with
built-in control switches.
Mobile electronics
Application Rate Sensors
Rate sensors are used to measure the speed of the conveyor. Slotted
disk sensors can be mounted on a conveyor drive, idler or jackshaft.
Inductance type sensors can read from a sprocket or gear mounted
on the conveyor drive or jackshaft.
Granular Components
PART NUMBER DESCRIPTION NOTE
405-0075 Single-Conveyor Switchbox with Off/Auto/GSO w
405-0098 Dual-Boom Switchbox with Off/Auto/GSO—to twin Mid-Tech® Connectors w, x
404-0062 Switchbox with Off/Auto/GSO y
404-0050 Off/Auto/GSO Panel-Mount Switch y
105-0024 Air-Max Switchbox, Dry only (LH/RH Boom off) z, w
105-0025 Air-Max Switchbox w/Wet Boom (LH/RH Boom off) z, w
405-0036 Boom Status Cable
PART NUMBER DESCRIPTION NOTE
16-05000 Gear Sensor ff, dd
16-05004
Gear Sensor w/208 (6.0 m) Cable
aa, dd
120-0009
360 Slot Application Rate Sensor w/108 (3.0 m) Cable
cc
120-0042
Inductance Rate Sensor w/98 (2.7 m) Cable
aa, dd
67-00004
19 Round Shaft Coupler for 120-0009
PART NUMBER DESCRIPTION NOTE
105-0007 Chemical Flow Monitor, Alarm Console–4 Position
405-0066 Hopper Level Interface Cable
600-0056 12 VDC Motor Assembly w/Sensor
120-0008
30 Slot Application Rate Sensor–128 (3.7 m) Cable
ee
120-0008-P
60 Slot Application Rate Sensor–128 (3.7 m) Cable
ee
120-0040
Proximity Sensor w/68 Cable, Amp Connector
mm
120-0043
Proximity Sensor w/98 Cable, Amp Connector
mm
105-0104 40 AMP Granular Bin Driver Module
105-0105 10 AMP Granular Bin Driver Module
602-0014
128 (3.7 m) Signal Extension Cable
HYDRAULIC MOTORS
COAPPLICATION COMPONENTS
PART NUMBER DESCRIPTION NOTE
28-05004
Hydraulic Motor w/Sensor 300 RPM @ 10 GPM 38 l/min, 7.7 in
3
(126 cm
3
)/rev.
(Painted Black w/Mounting Hardware)
1
600-0060-P Hydraulic Motor w/Sensor 500 RPM @ 10 GPM 38 l/min, 4.6 in
3
(75.4 cm
3
)/rev.
1
600-0061-P Hydraulic Motor w/Sensor 144 RPM @ 10 GPM 38 l/min, 15.9 in
3
(261 cm
3
)/rev.
1
OPTIONS
28-10001 Seal Kit for 28-05004 Hydraulic Motor
600-0090 Sensor for above Hydraulic Motors