Owner`s manual

8
Supplied Accessories
Owner's Manual Quick Start Guide Registration card
Remote Control
(NF801UD)
Batteries
(AAA, 1.5V x 2)
TV base and 3 screws (M4 x 20)
AC power cord
Attaching the Base
You must attach the base to the unt to have t as a table top
unit. Be sure the front and rear of the base match the proper
direction.At least 2 people are requ red for these steps.
2
Spread a thiclc and soft cloth over a table as shown at step 2,
Place the main unit face down onto it. Make sure not to
damage the screen.
insert 2_hooks under the
bottom of the man unt _.
nto base hoes (shown by /
arrow ,i)), then move the
base in the d_rectlon as
shown by arrow @, until it
stops and the screw holes
are aligned. Make sure not \_//
to put the AC power cord between the base and the unrL
No_
Make sure the component code on your universa 1emote control
is set to our brand, Ref_,r to the manua accompanying your
remote contro for moro dr, tails.
Wr, do not guarantee I00% interoperabil ty with all universal
remote contro s,
Installing the Batteries
install the batteries (AAA, 1.5V x 2) matching the polar ty
indicated insde battery compartment of the remote control.
Ion,mow b_,ba!,efrom hs in/:
• Unscmwthe Phllips he_d screws n st_.p 3,
A_.r the screws am removed, move the base in the opposite dimcLion
as shown by arow in st_,lD2,then pu the base up towad the rear of
the unit. Be tariffs not to dlx)p the base when you mmow' it,
I'_:W'[qen art chin£ the b.......... that all .......... tghty fdstened. If
the base s not propery attached, it could causethe unit to fJI, result ng
n injuries s we as damge to the unit.
• Make sum to use a tabe which can suppolt the weight of this unit and
s a_ger than ths unt.
• Make sum the _wbe is in stabe location,
• When attaching the base, ensure that FRONT t wr tten on the base is
upward. If it's not upward, the 2 hooks don't fit in the base,
Mounting the Unit onYour Furniture
Screw this unt on your furnture t ghtiy usng wood screw (not
supplied) in the hole at the back of the base as shown,
• Recommended screw dimens on :0,20I x 0.788 inches(S,1 x _0 ram)
rear ofthe unit
screw hole