Owner`s manual

4
Use <1/1_ to select the desired Iocat on setting,then press
OK.
13
!ii!_}!!!
Initial Setup
This section will guide you through the unit's nitiaJ setting
which ndudes selecting a language for your on screen menu
and autoprogram, which automat tally scans and memor zes
v ewabie channels.
Before you begin:
Make sure the unt is connected to antenna or cable,
1 After making all the necessary connect ons,
press (_) to turn on the unit.
• It may take a few moments to turn on the unt for the
first time.
• [initial Setup] menu appears automat tally after the
unt is turned on.
2 Use A/V to select the on screen language from the
choices (Engl sh / Espafiol/Franca s) on the right sde of the
IV screen, then press OK.
3 Use A/V to select [Antenna] forTV channels or [Cable]
for CAIV channels, then press OK.
• [Autoprogram] will begin.
No_e
Select [Retail] store, the unit will be set up with
predefined setting for retail d splays.
Select [Home], the unit s set to maxmze the energy
efl]c ency for home setting and t can be adjusted
through a choice Of picture and sound quality accord ng
to Tour preference,
When the ntial setup s completed,the lowest
memorized channel with the confirmation message of
the Iocat on sett ng will be displayed on the]V screen.
You must set [Home] in step 4, Otherwise, [Picture]
and [Sound] settings you adjusted will not be
memorized after the unt goes into standby mode.
If you are, not receiv ng a signal flsm your cable serv ce, contact
the Cube prov de_:
If you pless (_ or MENU durng autoplsgram, ths setup of TV
channels will be canceled,
The init I utoprogl m function can be executed for ether
[Antenna] or [Cable] ony once, When you chdnge the
connect on (Antenn / Cab e), set [Autoprogram] agan. ,,,,Bp.19
If them is no si£na input fi-om the sntenn terminal and no
operat on for several seconds after you turn on the unit, he pful
hints appears. Folow the instruct ons listed on theTV screen,
After an initial setup is completed...
• If you want to scan the channels automatically again,
[Autoprogram] nlmi.p.19
• You can add the desired cable and analog channels
unmemorized by autoprogram.
[Add Channels] ,,_ p.20
• If you want to change to another language.
[Language] n,mi,p.25
• If you want to change the location setting.
[Location] n,mi.p.24
:?i
!i!ili_!
:!:'ii