Installation Instructions

Installation and use
MSK-101-MM| Installation instructions v1.7 OCT 2018 |msk-101-mm_instructions_en_us v1.7|© 2017-2018 Inxpect SpA
11
Before installation
Necessary components and tools
l Wi-Fi dongle (product code: WSYNC-RJ-
WIFI or WSYNC-RJ-WIFI-US).
l Android or iOS device with Wi-Fi enabled
and the Inxpect Security application
installed (see "MSK-101-MM" on page5).
IMPORTANT: to ensure correct
functioning, allow all requested
permissions for the application.
l Only for barrier applications and if
necessary, adapter for assembly (product
code: MSK-101-BM) (see "Barrier
configuration" on page7).
l Two screws up to M4 (No.6) for fastening to
the wall or to the junction box.
l Screwdriver, wire stripper and fastening
tools not provided.
Prepare for installation
NOTICE: to ensure effective functioning, the
sensor must be installed in the best possible
position and configured correctly. Carefully follow
the instructions below.
Before installing the sensor, perform the following
operations:
1. Define the sensor application type (see
"Applications" on page5).
2. Define the installation position, considering
possible interferences (see "Interferences" on
page9).
3. Define the height of installation for the sensor
to obtain the desired field of vision (see "Field
of vision" on page8).
4. Run a shielded cable with the necessary
conductors from the alarm control unit to
connect the sensor (power supply and relay
outputs).
5. Only for installations with MSK-101-BM
adapter, define the direction of the sensor
(see "Barrier configuration" on page7).
Warnings
NOTICE: damage to the device. Do not let dust or
water near the sensor during installation.
Install MSK-101-MM
1. Assemble the sensor:
For... And... See...
barrier
applications
with
adapter
MSK-101-
BM
sensor
directed
to the
right
"Assemble the
sensor with the MSK-
101-BM adapter
(sensor directed to
the right)" on the next
page
barrier
applications
with
adapter
MSK-101-
BM
sensor
directed
to the
left
"Assemble the
sensor with the MSK-
101-BM adapter
(sensor directed to
the left)" on page13
all other
cases
- "Assemble the
sensor" on the next
page
2. "Connect the sensor to the alarm control unit"
on page14.
3. "Direct the sensor" on page15.
4. " Connect the dongle and configure the
sensor" on page15 .
5. "Fasten the sensor" on page16.
2