Manual

Step 1: Remove the OEM system by loosening the
clamps rearward of the catalytic converters. Remove
the Resonator assembly support bracket. Working
front to rear remove the complete OEM system. Be
sure to retain all hardware and rubber insulators as
they will be needed to install your new MAGNAFLOW
system.
Step 2: Use the OEM clamps to attach the Resonator
Assembly to the catalytic converters. Next attach the
D/S and P/S Mid Pipes to the Resonator Assembly
and secure with the supplied clamps. Attach the
Tailpipe Assemblies to the Mid Pipes and secure with
the supplied clamps. Locate all hangers into existing
rubber insulators. Re-attach support bracket.
Step 3: With all components mounted loosely, adjust
the system for overall aesthetics and clearance of
frame & bodywork. (MAGNAFLOW recommends at
least 1/2" of clearance between the exhaust system
and any body panels to prevent heat-related body
damage or fire.)
Step 4: Once a final position has been chosen for the
new system, evenly tighten all fasteners from front to
rear. The supplied band clamps must be VERY tight
to properly align the pipes and prevent leaks
(Approximately 40ft-lbs). U-bolt clamps should be
tightened to approximately 30-35ft-lbs. Inspect all
fasteners after 25-50 miles of operation and retighten
if necessary.
Mufflers, Converters,
Systems and Tips
INSTALLATION INSTRUCTIONS
15090
2011 Camaro C/B Comp 6.2L
Warning: When working on, under, or around
any vehicle exercise caution. Please allow the
vehicle's exhaust system to cool before removal,
as exhaust system temperatures may cause
severe burns. If working without a lift, always
consult vehicle manual for correct lifting
specifications. Always wear safety glasses and
ensure a safe work area. Serious injury or death
could occur if safety measures are not followed.
** Magnaflow Performance Exhaust recommends professional
installation on all their products
Magnaflow Performance Exhaust - 22961 Arroyo Vista Rancho Santa Margarita, CA 92688
Main #: 1-800-990-0905 Technical Support: 1-800-959-9226 ext 4500
03/28/11
Rev: 000
RESONATOR
ASSY
P/S MID-PIPE
D/S MID-PIPE
D/S TAILPIPE
ASSY
P/S TAILPIPE
ASSY
[4] 2.50" CLAMP