Owner's manual

MAGNAFLOW: 22961 Arroyo Vista - Rancho Santa Margarita, CA 92688 | 1(800) 990-0905
Technical Support: 1(800) 959-9226 | Email: [e-mail]
Step 1. Begin by removing the two rear chassis
stiffeners by the muffler inlets. This will allow access to
the exhaust system.
Step 2. You will need to cut the OEM exhaust system
to remove it and install the new Magnaflow system.
Measure and cut 18.750" forward of the hanger end on
the passenger side pipe and 18.375" forward on the driver
side. Remove mufflers and retain rubber hanger
insulators to install the new system
Step 3. Begin installing the new system by attaching
the Driver and Passenger inlet pipes to the cut portion of
the OEM system using the supplied 2.25" clamps. Leave
clamps loose for final adjustment.
Step 4. Next attach the Driver and Passenger Muffler
Assemblies to the Inlet Pipes using the supplied 2.50"
clamps and by fitting the hangers into the rubber
insulators.