Owners manual

MAGNAFLOW: 22961 Arroyo Vista - Rancho Santa Margarita, CA 92688 | 1(800) 990-0905
Technical Support: 1(800) 959-9226 | Email: [e-mail]
Step 7. Once a final position has been chosen for the
new exhaust system, evenly tighten all clamps from front
to rear using the torque specifications on page one of the
instructions. Inspect all fasteners after 25-50 miles of
operation and re-tighten if necessary.
19265 6/13/16 REV 000
Step 5. Install the Muffler Assemblies to the X-Pipe
Assembly with the supplied 3.00" clamps and engage the
welded hangers to the rubber insulators. Leave all
clamps loose for final adjustment of the system.
Step 6. To re-connect the wiring harness plugs to the
Valve motors you may need to cut their plastic anchors.
After having done this attach the plugs to the motors and
re-anchor the wires with a supplied Zip Tie.