Owners manual

MAGNAFLOW: 22961 Arroyo Vista - Rancho Santa Margarita, CA 92688 | 1(800) 990-0905
Technical Support: 1(800) 959-9226 | Email: [e-mail]
Step 1. To begin the removal of the OEM system you
will need to unfasten the X-Pipe inlets at factory clamp
locations. Next un-clip the ground strap from the
passenger side muffler hanger. Working rearward (with
the exhaust supported) extract the hangers from the
rubber insulators and remove the OEM exhaust. Do not
discard or damage the rubber insulators as they will be
used to install the new exhaust system.
Step 3. Attach the Mid-pipes to the Resonator Assembly
with supplied 2.50 Clamps and fit hangers into rubber
insulators. RemeMber to re-attach the ground strap to the
hanger. At this point you have two options for tips.
Magnaflow supplies a Quad tip setup that can be clamped
to the Mid-Pipes and held in place with hangers and the
installation is complete.
Step 2. Begin installing of the new system by attaching
the Driver and Passenger side (Passenger is the longer
of the two pipes) inlet pipes to the outlets of the OEM
system using the supplied 2.50" clamps. Next attach the
Resonator Assembly to the inlet pipes with supplied
clamps and insert the hangers into the rubber insulators.
Step 4. To install the OEM tips they must first be
removed from the stock exhaust system. You will need to
loosen the tip clamps and break the weld holding them to
the mufflers, both sides.
19209 12/4/14 REV 000