Owners manual

MAGNAFLOW: 22961 Arroyo Vista - Rancho Santa Margarita, CA 92688 | 1(800) 990-0905
Technical Support: 1(800) 959-9226 | Email: [e-mail]
Step 5. Once a final position has been chosen for the new
exhaust system, evenly tighten all clamps from front to rear
using the torque specifications on page one of the
instructions. Inspect all fasteners after 25-50 miles of
operation and re-tighten if necessary.
19172 10/05/14 REV 000
Step 4. Once the rear valance is back in place, loosely
fasten the Tip sub-assemblies together while on the ground
using the supplied fasteners. Now you can attached the Tip
assembly to the Muffler assemblies using the provided 2.50"
clamps. Plug the wiring into the valve motors checking for
cleareance.