Owners manual

MAGNAFLOW: 22961 Arroyo Vista - Rancho Santa Margarita, CA 92688 | 1(800) 990-0905
Technical Support: 1(800) 959-9226 | Email: [e-mail]
Step 1. To remove the OEM exhaust system you will first
need to remove the rear valance. To do so you will need to
remove the two 10mm bolts behind each reflector, the two
10mm bolts behind the license plate and two more 10mm bolts
just underneath the license plate. Then you will need to
remove the five 8mm bolts on both sides of the valance
underside. Next, with the rear valance removed unplug the
motor on both inlet pipe valves and unfasten the inlet pipe from
the catalytic converter. Disengage all welded hangers from the
rubber isolators. The OEM system may now be removed. Be
sure not to damage and retain all mounting hardware and
hanger insulators as they will be re-used to install your new
Magnaflow system.
Step 3. Next, Loosely attach the Muffler Assemblies to
the Inlet pipes using the provided 3.00" clamps. You will
then need to fasten the provided cross bracket in place
between the two muffler assembles using the provided 1/4"
fasteners. Insert all hangers into the rubber isolators. At this
point you can re-install the rear valance.
Step 2. To Install your Magnaflow system start with The
OEM system and your new system sitting on the ground next
to each other. Switch the valve motors from the OEM system
to the new system re-using the OEM fasteners. Next position
the Inlet pipe assemblies over the transmission axle, loosely
attaching the Inlet pipes to the catalytic converter using the
OEM clamp. Plug in the valve motor wires once the inlet
pipes are in position. Leave all clamps and fasteners loose
for final adjustment of complete system.
19172 10/05/14 REV 000