Owners manual

MAGNAFLOW: 22961 Arroyo Vista - Rancho Santa Margarita, CA 92688 | 1(800) 990-0905
Technical Support: 1(800) 959-9226 | Email: [e-mail]
Step 1. Begin removing the OEM exhaust system by cutting
both pipes going into the muffler assemblies. Measure and cut
9" forward of the welded hangers as shown. Next working front
to rear extract the hangers from the rubber insulators and
remove the OEM system. Retain insulators and clamps as they
will be used to install the new system.
Step 2. Begin installation of the new system by attaching both
Inlet Pipe Assemblies to the pipes you have just cut. Loosely
secure using the supplied 2.50" clamps. Engage the welded
hangers to the rubber insulators. Leave all clamps loose until
final adjustment.
Step 3. Next attachboth Muffler Assemblies to the Inlet Pipe
Assemblies using the supplied 3.00" clamps and fitting the
hangers into the rubber insualtors.
19103 9/25/14 REV 000
Step 4. Once a final position has been chosen for the new
exhaust system, evenly tighten all clamps from front to rear
using the torque specifications on page one of the instructions.
Inspect all fasteners after 25-50 miles of operation and
re-tighten if necessary.