Car Stereo System User Manual

The LCD display may fail to function normally

due to the vehicle’s battery condition, and could

require restarting the radio’s microprocessor if:

• The vehicle has been “jump started” from a

dead battery condition.

• The vehicle battery becomes very low and is

quick-charged.

• The vehicle battery is removed and replaced.

Should any of these conditions occur, simply

press and release the restart button on the radio

front panel using the tip of a ball point pen. This

will restart the radio’s microprocessor. After

pressing the restart button, you should recheck

to see if the radio functions normally.

Restart Button

If the fuse should blow, check that the wiring is

correct. If the wiring is correct, replace the fuse

with the same amperage rating as the original

(15 amp).

Replaceable Fuse

NAV

15 Amp

Replaceable Fuse

1. Open cover.

2. Lightly press the SD card into the holder to

release the card.

3. Reinsert the SD card until it clicks into place.

4. Close the cover.

5. Select the file from the SD card from the fea-

ture’s setup screen.

Rear SD Card Holder

SD Card