Specifications

4. Programming the MX-500

to Control Your Components

4. The remote will be flashing “SELECT BUTTON”.

Press the device you wish to program. (For example, to

program TV, press the TV button.)

5. The remote will be flashing “FROM TABLE”. Select the

device from which the scanned code will be selected.

(Important: If you have already relabeled your device

keys, your LCD screen will not look like the illustration

above. Select the appropriate LCD button for the “FROM

TABLE” using the labels as shown in the illustration on

page 10 of this manual. For example, if you have relabeled

AUX as LIGHTS, you would still push the bottom-left

button to access the AUX Code Table.

Note: Use VCR1, not VCR2, to access the VCR code

library.)

6. Point the remote control toward the component and press

either the UP or DOWN button on the LCD. (It will send

out a series of Power Off codes when the button is kept

pressed and the code numbers that are being sent are shown

on the LCD.) If the right code number is sent, the

component will turn off right after the code number is

transmitted.

7. Release the UP or DOWN button you were pressing as

soon as the device is turned off. If you should happen to go

past the one that turned off you device, just manually turn