PL21-UM.
PL21-UM.qxp 4/28/05 16:36 Page 2 The information enclosed will provide a ready reference of the operation and maintenance of your security system. Basic Operation This section details the simple day to day operations of your mobile security system. The enclosed procedures should be performed every six months to insure that all functions are operating properly. To perform a basic operations test, repeat the following procedures: 1. Exit the vehicle and close all protected entrances. 2.
PL21-UM.qxp 4/28/05 16:36 Page 3 Primary Feature Operations (continued) Override Operation: (Security system is Armed) 1. Enter the vehicle, the security systems will begin sounding at this point. Make sure that the switch is in the OFF position. 2. Place the ignition key into the ignition switch and turn the ignition switch to the ON position. 3. Within 5 seconds of turning the ignition key ON, put the valet switch into the ON position. 4. The horn/siren will stop sounding. 5.
PL21-UM.qxp 4/28/05 16:36 Page 4 Optional Features (continued) Last Door Automatic Arming: If your security system was programmed to automatically arm without using the transmitter, repeat the following procedures to test and operate this feature: 1. Enter the vehicle and close all the entrances. 2. Set the ignition key switch to the on position and wait for 5 seconds. 3. Set the ignition key switch to the off position and exit the vehicle.
