Owner’s/Installation Manual - + MENU CAM MODE POWER 7” Color LCD Monitor Model: M135C-4 For Technical Assistance, please call (800) 638-3600, or visit www.magnadyne.
Table of Contents Introduction............................................................................................................................... 2 Warning / Caution...................................................................................................................... 2 Monitor Features and Controls.................................................................................................. 3 Remote Control Functions............................................................
Monitor Features and Controls - + MENU CAM MODE POWER 2 3 4 5 1 1. Volume Buttons (- and +): Press to adjust the speaker’s volume. 2. Menu Button: Press to access the monitor’s adjustment features. 3. Camera Selection Button (CAM): Press to select the desired camera view: Left, Right, Front or Rear. 6 7 4. Camera Display Configuration Button (MODE): Press to select different camera display configurations. 5. Power Button: Press to turn the monitor on or off. 6.
General Operation Turning the Monitor On: The monitor is operational by activating the ignition key then manually pressing the power switch on the unit. MENU CAM MODE POWER Selecting the Camera View Press to select the desired camera view. Note: When the camera is automatically selected (Example: the vehicle is put into reverse) the camera image will automatically override the selected camera image.
General Operation Monitor Adjustment To access the monitor adjustment features, press the MENU button. Use the - or + buttons to make adjustments to the selected function.
Installation Instructions Pedestal Mounting the Monitor 1. Loosen the thumb wheel on the base support so the nut attached to the thumb wheel can slide into the monitor’s mounting channel. 2. Slide the thumb wheel nut into the channel on the back of the monitor. 3. Position the monitor to the desired height and tighten the base support thumb wheel. 4. Adjust the tilt knob. 5. Use the double-sided foam (supplied) or mounting screws (not supplied) to secure the base support to the desired location.
Technical Specifications Display Size: 7-inch Display Format: 16:9 System: PAL/NTSC Power Supply: 12-32V Power: 12W Picture Resolution: 800x480 7
Warranty ONE (1) YEAR LIMITED WARRANTY Magnadyne Corporation or its authorized agents will within one year from the date of sale to you, repair, replace or refund the retail sales price of said product or any part thereof, at the option of the Magnadyne Corporation or its authorized agents, if said product or part is found defective in materials or workmanship, when properly connected and operating on the correct power requirements designated for the specific product.
