Specifications

HWDOC-X279-en-A 14 www.honeywellprocess.com
2.2 Installing the ControlNet card inside the Magma Expansion Chassis
Notice! Ensure that the Magma Chassis is turned off.
Before installing third party hardware cards inside the Magma Chassis, see the following sections in the PCI Expansion Chassis User's
Guide and Host Card Installation Guide:
 Hardware Installation
 Verify Installation
To install the ControlNet card inside the Magma Expansion Chassis
1. Open the Magma Chassis. For instructions, see the PCI Expansion Chassis User's Guide and Host Card Installation Guide.
2. Identify the correct slot number in the Magma Expansion chassis for installing the ControlNet card.
ControlNet card
Slot No.
Slot Type
ControlNet PCIC-02 card
2
PCI Slot
3. Close the Magma Expansion Chassis. For instructions, see the PCI Expansion Chassis User's Guide and Host Card Installation
Guide.
4. Position the Magma Expansion Chassis so that the supplied PCI expansion cable will conveniently reach from the connector of the
host card to the connector on the back of the chassis.
5. Connect the interface cable to both Magma Expansion Chassis and host card.
6. Tighten the thumbscrews at both end of the cable.
7. Connect all power cords to the Magma Expansion Chassis and Dell server. The Magma Expansion Chassis power-in receptacle is
located at the rear of the chassis.
2.3 Installing the Magma Expansion Chassis in a server cabinet
If you are installing the Magma Expansion Chassis in a server cabinet, you should perform these steps before connecting the PCI
expansion cable between the Magma Expansion Chassis and the Dell server.
To install the Magma Expansion Chassis in a server cabinet
1. Attach the rack mounting ears provided with the Magma Expansion Chassis to the chassis. For instructions, see the PCI
Expansion Chassis User's Guide and Host Card Installation Guide.
The Magma Expansion Chassis must be mounted in the server cabinet or equipment rack immediately above the server, such that
the server chassis provides a surface to physically support the Magma Expansion Chassis.
2. Connect the interface cable to both Magma Expansion Chassis and host card.