Installation guide

MAGMA
Chapter 4 Verify Installation 9
 Click on the ‘+’ sign to the left of the PCI Bus to see all PCI
Bus connections.
 Click the ‘+’ sign to the left of the line containing the words
“Express Root” or something similar. You should now see the
PCI Standard PCI-to-PCI bridge immediately below it.
When installed correctly, you will see two “PCI-to-PCI bridges” below
your system’s PCI Express Root Port.
If everything is OK, then the Mobility eCard Driver installation is
complete and you can proceed to the separate Expansion Chassis
User’s Guide for help installing 3
rd
Party PCI Cards.
If the installation was unsuccessful you may see a small yellow
(bang) in front of the PCI to PCI Bridge, or it may not be visible at all. In
either case, proceed to
Chapter 5 Troubleshooting for installation
problems.
If any of these devices are not displayed as shown above, you should
shut down your system (laptop first, then the expansion chassis) and
reconnect the cables and the Magma EC54 to ensure that you have a
solid connection. Restart the Magma expansion chassis, followed by the
laptop. Next, try to verify the installation again, as shown above. If you
are still having problems, review
Chapter 5 Troubleshooting before
contacting Mobility Technical Support at [phone].