Instructions / Assembly

7
USING GRILL WITH ON-BOARD CNG (NATURAL GAS) SYSTEMS
Magma's grills are designed for use with small disposable propane canisters or with pre-regulated
low-pressure propane and optional low-pressure valves. Running high-pressure propane fuel supply
lines on a boat is in violation of American Boat & Yacht Council (ABYC) guidelines and is not
considered a safe application. Additionally, impurities found in larger refillable propane tanks may
clog the small orifices in the high-pressure control valve/ regulator causing it to lose performance
capabilities and eventually fail. Regulating these tanks to 1/2 PSI and using this pre-regulated
propane with the correct low-pressure valve will insure safe, efficient performance of the grill.
)-0/24!.4s$/./4#/..%#4!()'(02%3352%3500,9(/3%
FROM A NON-REGULATED TANK DIRECTLY TO GRILL.
s-AGMAONBOARD#.'NATURALGASVALVESALLOW-AGMAGRILLSTOBEINSTALLEDTOANEXISTINGONBOARD
PREREGULATEDLOWPRESSURE#.'NATURALGASSYSTEM
s5SEONLY-AGMA4YPE,OW0RESSURE#.'NATURALGASCONTROLVALVES6ISITOUTWEBSITEAT
www.MagmaProducts.com to view valve application guide. See your local dealer for proper hose and fittings.
Problem
Electrode covered with grease or residue
Igniter/electrode too far from burner
Electrode wire loose, disconnected, or corroded
Wire is shorted causing spark from wire before
electrode
No spark being generated
No gas flow
Obstructed gas flow
Excessive cooking temperature
Grease and/or residue build-up
Excessive fat in meats
Excessive oils in marinades
Obstructed gas flow
Flame too low
Wind directly on burner
Obstructed gas flow
Grill not level
Grease or residue build-up
Excessive fat in meats
Excessive oil in marinades
Clean electrode
Adjust electrode until proper spark appears
(see page 5)
Clean, adjust & reconnect wire between igniter
& electrode, see Complete Disassembly (page 5)
Replace Igniter, Electrode & Wire
See website for part number
Adjust electrode until proper spark appears.
5NSCREWIGNITERPUSHBUTTONREMOVEINSPECT
“AAA” battery, replace “AAA” alkaline battery if
necessary, reinstall & re-assemble push button
Replace Igniter, Electrode & Wire
See website for part number
Check fuel level, replace canister or
refill cylinder
Clean burner and valve orifice.
Remove debris/spider webs
Operate only on low when lid is closed
Reduce flame level
,EAVELIDOPEN
5SEWATERSPRAYTOCOOL
Clean components
4RIMFATFROMCUTSOFMEATBEFOREGRILLING
5SENONOILBASEDMARINADES
Clean burner and valve orifice.
Remove debris/spider webs
Increase flame
Block wind when opening lid
Clean burner and valve orifice.
Remove debris/spider webs
,EVEL'RILL
Clean components
4RIMFATFROMCUTSOFMEATBEFOREGRILLING
5SENONOILBASEDMARINADES
Hot Spots
Blow-out
Yellow sooty
flame
Flare-up
Burner will
not light even
with match
Burner will
not light with
igniter
TROUBLE SHOOTING GUIDE
Possible Solution Possible Cause