OWNER’S MANUAL For Models: A10-207 • A10-217 Stainless Steel Combination, Stove & Gas Grill ® U.S. PATENTS 4,788,962 5,330,154 5,414,090 D 292,163 Other Patents and Design Patents Pending For questions regarding performance, assembly, operation, parts, or returns, contact the experts at MAGMA by calling (562) 627-0500 7:00 a.m. - 5:00 p.m. Pacific Time Monday thru Friday or e-mail us at mail@MagmaProducts.com Read these instructions carefully before use.
IMPORTANT SAFETY WARNINGS READ ALL INSTRUCTIONS BEFORE OPERATING. • USE OUTDOORS ONLY. • DO NOT USE THIS APPLIANCE INSIDE THE BOAT OR ANY ENCLOSED SPACE. • GRILLS RADIATE HEAT. CLEARANCE FROM COMBUSTIBLES, 24” SIDES AND BACK. NEVER USE UNDER AWNINGS, PATIO COVERS, ETC. • USE PROPANE GAS ONLY. FUEL STORAGE SHOULD BE IN COMPLIANCE WITH THE AMERICAN BOAT AND YACHT COUNCIL (ABYC) STANDARDS A-1 (9), MARINE LIQUIFIED PETROLEUM GAS (LPG) SYSTEMS. • FOR NATURAL GAS APPLICATION CONTACT MAGMA.
SETTING UP YOUR GRILL Mounts sold separately. See our website www.MagmaProducts.com for mounting options. Level Flat Surface 2 1 4 3 1 Select and install appropriate Magma mount in your desired location. Prior to installing the grill, check that mount does not easily move with a reasonable force applied. 2 Next, decide if gas control valve will be easier to access from the center right side or center left side of grill. This will be based on your placement of the mount (see picture front cover).
9 8a 8 7 7 Install radiant plate & dome over burner on fire pan ridge. 8 Install grill grate by rotating grate so that both grill grate tabs slide under the holding clips (8a), locking grate and all internal components in correct position. 9 Insert the turbo venturi tube into the threaded pipe on the bottom of the grill body and firmly tighten the holding nut so it doesn’t turn when rotating valve. Venturi tube should be stowed with valve in a clean dry environment when not in use.
USING GRILL WITH ON-BOARD LPG (PROPANE) SYSTEMS • Magma On-Board LPG (Propane) Valves & LPG (Propane) Low Pressure Gas Grill Connection Kit allow Magma Grills to be installed within a boats existing on-board, preregulated low pressure LPG (Propane) system. • Use only Magma Type 3 Low Pressure LPG (Propane) Valves. See our Valve Application Guide at www. MagmaProducts.com for correct valve. • In North America use Magma A10-225 LPG 10' Gas Grill Connection Kit in conjunction with Type 3 Valve.
OPERATING PROCEDURES WARNING: Do not overheat grill. Magma grills do not require pre-heating. Stainless Steel loses anti-corrosive characteristics when subjected to extreme heat. Most grilling is done on low temperature with the lid closed. If medium or high heat is required, grill with lid open. LIGHTING INSTRUCTIONS • Open lid during lighting. • Depress knob and rotate counter-clockwise to the “HIGH” flame position. • Push Piezo Igniter. • Visually confirm ignition. • Turn knob to adjust flame.
To help create your own Magma gourmet experience every time you grill, please check these important critical points prior to lighting your grill. • Mount is secure and grill does not move. • Grease tray and fire pan are clean from excess drippings to reduce flare up and ensure even air flow. • Lid is correctly positioned to operate freely and is in best position for blocking the wind. • Venturi tube, burner, threaded burner pipe and valve orifice are free of obstructions, such as spider webs.
MAINTENANCE About Stainless Steel Stainless steel exposed to prolonged periods of high heat will change color and texture. Magma grills require no preheating. Not preheating will keep your grill cooler and greatly extend its life and beauty. Texture and color change is normal on components and will not affect the product's performance. Stainless steel scratches easily and should never be cleaned with abrasive pads, brushes or abrasive cleaners.
REPLACEMENT PARTS A10-207 A10-217 Original Size Party Size 10-153 Cooking Grill 10-453 Cooking Grill 10-665 Radiant Plate & Dome 10-765 Radiant Plate & Dome 10-657 Burner 10-657 Burner 10-658 Fire Pan 10-758 Fire Pan 10-651 Complete Handle Assembly & Fasteners 10-651 Complete Handle Assembly & Fasteners 10-752 Lid w/hinge & fasteners (no handle) 10-652 Lid w/hinge & fasteners (no handle) 10-759 Outer Bowl 10-659 Outer Bowl 10-960 Piezo Igniter w/Wire Electrode & Screw 10-960 Piezo Igniter
TROUBLE SHOOTING GUIDE Problem Possible Cause Possible Solution Burner will not light with igniter Electrode covered with grease or residue Clean electrode Electrode not directly under burner ground strap Adjust burner so burner ground strap is directly above electrode Electrode wire loose, disconnected, or corroded Clean, adjust & reconnect wire between igniter & electrode, see Complete Disassembly (page 7) Wire is shorted causing spark from wire before electrode Replace Igniter, Electrode & Wir
ACCESSORIES 9 Piece Stainless Steel Nestable Cookware Magma® Marine Kettle® Grill Cover/Tote Bag Original & Party Size Pacific Blue, Royal Blue, Captain’s Navy, Jet Black, Forest Green and Burgundy Fish & Veggie Grill Tray Stainless Steel Finish or Teflon® Select Non-Stick Finish LPG (Propane) 10’ (3 m) Hose Kit (for on-board LPG (Propane) systems) Control Valve - Type 3 (for on-board LPG (Propane) or CNG (Natural Gas) gas systems) Stores in less than 1/2 cubic foot 9 Piece Teflon® Select Non-Stick N
