Owner manual

1-800-MAGLINE (624-5463) Page 25 www.magliner.com
CooLift
®
Area Description
Method of
Inspection
Normal Condition
Findings
Pass or
Fail
Timing Notes
Suspension
Mounting hardware is tight
• Front wheel yoke • Rear caster frame • Main axle mounts to frame and
axle clamp
• Cotter pins for main wheels
Manual inspection All hardware is tight Monthly
Linkage System
Hardware is properly installed and undamaged
• Spring pins • Washers • Springs
Visual inspection
All hardware is in place and in good condition
Monthly
Linkage System Link pins Visual inspection
• Pins are straight with no signs of wear • Pin plating is not cracked or damaged
Monthly
Linkage System
Links
• Minimal play between pins and
bushings
• Bushings are not working out
of links
Manual / Visual inspection
• Links are straight with no signs of
damage or wear
• Minimal play between pins and links • Bushings are ush with side of the
links
Monthly
Linkage System
Link pins are not loose in deck, frame or sync links
Manual inspection
Minimal play between pins and deck, frame and synch links
Monthly
Operator Interface
Internal mounting hardware is tight
• Vertical slide cover screws • Vertical slide mounting screws • Guide block cotter pins in rod • Pump mounting plate • Pump mounting screws • Pump band clamp • Battery box mounting screws
Manual inspection
Components are tight to mounting surfaces
Monthly
Operator Interface
Brushes • In front of enclosure • In door
Visual inspection
• Brushes are not worn or damaged • Brushes are properly positioned in
holders
Monthly
Electrical Switch panel Manual inspection
• No loose components • Cover for charger port is intact
Monthly
Welds Frame - general Visual inspection No cracks or damage Monthly Welds No cracked welds Visual inspection No cracks or damage Monthly