User manual

applied to a line of text with more than one font size, the largest font size is used. For example, if a line
contains 90% and 100% text, the line spacing is calculated on 100%.
Tracking
Whereas kerning (see below) changes the spacing between two characters, tracking changes the spacing
equally within a region of text. An EM is the width of the capital letter "M" in the current font and font
size. It is therefore relative to the font size and not a fixed value.
1.
Select the region to which you want to apply
tracking.
2.
Type a value into the Tracking text box (values are
in 1/1000ths of ems).
From the keyboard you can increase or decrease the tracking by pressing "Alt + Right arrow", or "Alt +
Left arrow". Each key press changes the tracking by 10/1000.
Kerning
Kerning lets you alter the space between two characters (so
affects horizontal spacing).
Most good fonts have auto-kerning which means they already move appropriate pairs of characters
together slightly, as you can see from this diagram:
Auto-kerning off Auto-kerning on Manual kerning
Kerning is measured in "ems" (enter values in 1/1000ths of "ems".) You can either type the kerning value
in the text box, or click the arrows to nudge the values.
It shares the same key shortcuts as above. If there is just a cursor, it alters the kerning, but if there's a
selected range of text, then it alters the tracking. Each key press alters it by 10/1000ths of a em.
Baseline shift
Baseline shift allows you to move part of a line up or down.
Positive values move the text upwards, negative
downwards.
The baseline is the imaginary line at the bottom of characters.
Select the characters for which you wish to change the baseline shift then enter a value in the Baseline
shift
text box.
The effect of selecting AG and then applying a downwards baseline shift (i.e. -5pt).
Baseline shift is measured in points but you can use any of Xtreme Print Studio's standard measurement
units. Note that baseline shift is an absolute value, in points, and does not change if you change the font
size.
Paragraph Spacing
The last two fields on the end of the Text Tool InfoBar
allow you to set the spacing above and/or below
paragraphs.
This is particularly useful where you want half line spaces between paragraphs.
Like Microsoft Word, when you use both spacing above and below paragraphs, the spacing between
Page 174