User manual

Changing the font size
There are four ways to change the font size:

Type a new value into the size text box on the InfoBar and press ¿.

Or select from the Font size dropdown list on the InfoBar.

Or manually increase/decrease font size with the "Ctrl + Shift+ >" and "Ctrl + Shift+ <" keyboard
shortcuts. This applies only if all selected text parts are of the same font size.

Or use the Selector Tool to scale the whole text object.
Condensing and expanding characters (aspect ratio)
The aspect ratio is the ratio between the height and width of the text. Ratios over 100% make the text
wider than normal; under 100% make the text narrower.
To change the aspect ratio:
Type a new value into the Aspect text box on the InfoBar
and press "
¿".
Or use the Selector
Tool to stretch or squash the complete line of text.
It is not recommended to use values below 80% or above 130%. Better to use a special condensed
variant of the font family if available. Alternatively use the tracking control to adjust the spacing without
distorting the actual shapes of the characters.
Bold & Italic
Click the Bold or Italic
button on the InfoBar ("Ctrl + B" or "Ctrl + I")
This applies the bold or italic variant of the current font.
Attention: MAGIX Xtreme Print Studio does not allow you to apply italic or bold to text if the
necessary italic/bold font is not installed. However you can easily emulate the same effect. To embolden a
font, just give it a small line width and apply a line color. To slant a font, use the skew / slant feature of
the Selector Tool. Read more in the "Font menu" section
Text Underlining
Click the underline button on the InfoBar to apply an underline
to the selected text.
The underline color and size is automatically derived from the text color and size.
Underlining links
When you add a web address URL to some text, see the Web address dialog. You can decide to
automatically underline all links. This is a check box option on the web address dialog ("Ctrl + Shift +
W"). If you select this all linked text throughout the document is underlined, and the underline command
does not affect this.
If you apply a URL to a group that contains some text, then the text will not be underlined.
Justification or text alignment
Justification always applies to the complete line. Any selected region is ignored.
When using simple text the initial click position
on the page is taken as the origin for text justification.
Page 167