X3

100 Object editing
 Or use one of the two ripple modes (single-track ripple or
multi-track ripple (view page 48)) in order to cut the material
at th
e start of the range and move it to the end of the range.
"Overwrite" mode does not change the total length of the project. The new
material is only inserted at the start of the specified range:
The ripple function moves the material in the range together with the objects
behind. This changes the total length according to the length of the range:
Four-point editing
The four-point editing places new material into the project with the help of a
total of four marker points.
The motto: "whatever doesn't fit will be made to fit". A range is set in both
the source material as well as in the project, and one of the insert modes
described above is used. The function is the same for each mode (overwrite
and ripple): the section from the source material is inserted precisely into
the range specified in the arranger.
If bo
th ranges are coincidentally the same size (which is normally the
exception), then the new material will be stretched or pinched automatically.
The playback speed of the video is changed analog to the timestretching
applied to the audio track.
Because timestretching for an audio track is only possible and sensible to a
certain degree, the audio is removed from larger changes (above a factor of
2). A corresponding confirmation dialog appears first so that the procedure
may also be canceled when in doubt, e.g. to carry out a three-point cut.
www.magix.com