Manualshelf

11.0

ManualsBrandsMagix Xara ManualsApplicationsSamplitude
81828384858687888990
Table Of Contents
SAMPLITUDE QUICKSTART 89
Mixer effects
To set track effects in the mixer, open the mixer by pressing the "M" key. In the "Ins"
section, click on the arrow symbol of an effect slot in the corresponding channel. Selecting
effects is done the same way as described above. Use the "FX" button below the track's
channel fader to open a dialog to change the series of effects within the track.
Master effects
Master effects are applied to the entire material in a multi-track project. The signal is routed
through the effect, i.e. your audio card, before reaching the master output.
The master effects can only be set in the mixer, which can be opened by pressing the "M"
key. The sum range of the mixer is wider than normal tracks and can be identified via the
differently colored faders.
The effect slots for MAGIX plug-ins as well as VST and DirectX effects are located at the
very top. Below this, all of Samplitude's internal master effects can be found. The equalizer
can be used directly from the mixer or the equalizer dialog which can also be opened by
right clicking on one of the EQ controls.
The sequence of the master effects can be set in the FX routing dialog, which can be
opened via the FX button beneath the master faders.
CD mastering
CDs can be burned directly from within the project without having to export the project as
a wave file beforehand. Burning requires that a blank disc be inserted into the drive and a
valid TOC (Table of Contents) exists. For this, at least one CD track and one CD end
marker must be placed.
Set CD tracks
Position the play cursor where you wish to set the CD track marker. The marker menu can
be found above the track boxes in the VIP. Open it and select "Set CD track index". Repeat
this process until all markers that you wish to set are in place.