Manualshelf

11.0

ManualsBrandsMagix Xara ManualsApplicationsSamplitude
631632633634635636637638639640
Table Of Contents
PLAYBACK MENU 633
Attention: Please note that the length of reverberation times can lead to performance
problems.
Original sound may be used to ensure that the first track in "Original sound" mode is
switched to "Solo". The Pre-run time may also be specified in milliseconds to indicate
how long the delay between execution of the record command and the actual start of the
recording should be.
Autoscroll causes the graphical display to run the entire time before the play cursor
reaches the visible section. This provides a constant overview. Switch to "Autoscroll"
mode by ticking the "Active". "Active for zoom < 1 s"; autoscrolling even begins at very
high zoom levels of less a second.
Choose between "Page" and "Soft autoscroll" mode. With page scrolling, the section
changes before the play cursor moves outside the section, while with soft scrolling, the
play cursor always remains in the middle of your chosen section and the arrangement
moves along beneath it. At smaller buffer sizes (view page 27) (e.g. < 4096 samples),
scrolling will be softer.
Note: The autoscroll process can overload the processor in some cases, whereby
dropouts will occur in playback. Deactivate "Autoscroll" mode if this happens.
Scrubbing
If you press "0" on the number pad or the key combination "Alt + Shift + Page down" and
keep them pressed, Samplitude will switch to "Scrubbing" mode.
Here you can control the playback speed of the chosen track using the mouse.
The keyboard shortcut for scrubbing to the left is: "Alt + Shift + Left arrow"
The keyboard shortcut for scrubbing to the right is: "Alt + Shift + Right arrow"
There are four different scrubbing modes to choose from:
Shuttle: In this mode, the relative distance between the play cursor and the mouse
position can be used to control the speed. The play cursor follows the movement of the
mouse. The further you move the mouse from the play cursor, the faster playback will be.
This means:
Scrub control faders at the left edge = double speed backwards,
Scrub control fader in the middle = No movement,
Scrub control faders at the right edge = double speed forwards.
One speed: The preset scrubbing speed is 1.0, i.e. original speed. Press "Shift" to use the
scrubbing speed set in the "Speed" field and press "Ctrl" to halve this speed.
Two speed: Two speeds are provided for scrubbing. The object plays back slower or
faster depending on the distance between the scrub control fader and the mouse position,
whereby with slow scrubbing a speed of 0.25, or 1/4 of the original speed, is preset, and