Manualshelf

11.0

ManualsBrandsMagix Xara ManualsApplicationsSamplitude
531532533534535536537538539540
Table Of Contents
EFFECTS MENU 537
A/B/C comparison: To compare different dialog configurations, you can switch between
three different settings here. You can use this like a bypass function.
Bass, mids, and highs: You can set three frequency ranges for stereo, panorama, and
gain (see below).
Maximize: Use this controller to compress the side-chain signal, which also increases the
stereo transparency without influencing the mono compatibility. In "Multiband" mode, this
setting affects the middle bands.
Solo mode: In "Solo" mode the frequency bands can be monitored one at a time. This
greatly simplifies the process of changing filter parameter settings. As an example, you can
isolate a specific frequency range of a mix and change the aspect of the stereo image for
the range.
Multiband mode: The algorithm works with three frequency bands if this option is
checked. The "Multiband" mode is not automatically active when using the enhancer in the
mixer master section. This reduces the initial load on the CPU when selected in the master
section.
Direction pan mode: This switches between two panorama control modes:
If the option is checked, only the mono portion (the center signal) is considered when
changing the panorama setting. The panorama control functions as a directional mix
controller. A centered vocals recording can thereby later be moved to the left or right of the
stereo balance. The difference containing the sound sources allocated outside of the
center, remains unchanged.
In non-active state, the panorama faders work as normal. The complete stereo signal is
changed (mono and the remaining left and right portions).
Phasecorrel. (Phase correlator): This open the phase correlator. This option is very
useful when Solo mode is switched on: The base width and panorama setting for each
frequency band can be checked visually.
Reset: This button resets all settings.
Play/Stop: This button starts the realtime preview function.
OK: The algorithm is applied to the selected range of the sample. When using this in the
master area of the mixer, the parameters of the dialog window are used on the entire mix.
Cancel: Click on this button to close the dialog window, without calculating the effect.
When using this in the master area of the mixer, the parameters of the dialog window will
not be used on the entire mix.
Help: Here you can open the Help section.
Parameters for stereo manipulation
For each frequency band (bass, mids, highs) the following is available: