11.0

EFFECTS MENU 483
In some cases, only a portion of the selected range was analyzed according to the length.
To examine the entire range or object, click on the "Analyze all" button to the top right of
the dialog window.
Step 3: Now use the left mouse button to draw in the graphic display. The frequency
response of the filter changes according to the drawn curve. The blue curve also changes
while drawing: it now shows the frequency course almost reached by the sample after
application of the filter. The blue curve is therefore referred to as the corrected frequency
response.
Hint: If you use a faster PC, you can check the result in real-time after pressing the
play/stop button. The changes can be heard immediately. Otherwise you should use the
non-real-time preview ("Preview" button).
2. Filtering in "Direct draw" mode
You can also draw the desired frequency response (the blue curve) with your mouse.
Select "Direct" in "Draw" mode.
The yellow curve now displays the original frequency response as a comparison. A
change to the frequency response in this mode is only rarely required and can quickly lead
to overmodulation. For this reason you should confirm that you wish to "Prevent clipping"
by clicking on the button of the same name after every adjustment to the frequency
response.
By editing the blue curve you will of course indirectly change the frequency response of the
filter. To observe this first reset the filter by pressing the "Reset" button. Switch back to the
other "Draw" mode "Filter". You will now see that the filter curve is set back to zero. If you
then change back to "Direct draw" mode, edit the blue curve again and then switch once
more back to "Filter" mode, you'll see that the frequency response of the filter will have
changed.
3. "Dynamic filter" mode (fading between two filter curves).
Select the filter mode "Fade start". The displayed frequency response in this mode
corresponds to the left border of the chosen sample/object. You can edit this frequency
response in the "Filter" and "Direct draw" modes as well, in the same way as we described
in the previous two points. However, filtering will now also directly affect the marked range
of the sample or the object selected in the virtual project.
Switch to "Fade end" and edit the frequency response the same way. The displayed
frequency response in this mode now corresponds to the right border of the
sample/object. In this case filtering affects the end of the marked range of the sample or
the object selected in the virtual project.
Between both range borders the red filter curve changes and with it the blue curve with the
corrected frequency response. Here, the first curve fades into the second one.
There are three different methods for fading available in the "Expert" dialog.