Manualshelf

11.0

ManualsBrandsMagix Xara ManualsApplicationsSamplitude
421422423424425426427428429430
Table Of Contents
OBJECT MENU 429
After gluing, you can subsequently edit the original cut using the "Freeze object -> Edit
object freeze" function. When selecting this function, a single-track VIP will open as well,
which contains the original objects. These can then be edited individually.
Use the "Freeze object ->Unfreeze object" function to restore the original state of the
object.
Freeze objects
This function renders each selected object as a new wave file. The original object is
replaced in the arranger. If you have very calculation-intense real-time plug-ins active in an
object, you can increase performance by freezing. The original object always remains
preserved and can be re-edited using the "Edit object freeze" function or put back into the
arranger using "Object unfreeze".
"MIDI object freeze" replaces the MIDI objects in the audio return signal of a software
instrument with audio objects. The audio return signal must be routed to the MIDI track to
do this.
If more than one object is selected, the function will be applied to each individual object.
The frozen objects are grouped. Fade-in, fade-out, and object volume are not calculated,
since these properties are applied to the object properties of every new resulting object.
Edit object freeze
This command opens the freeze VIP function where the frozen object is saved. This VIP
contains tracks with the original object.
Changes made in the temporary freeze project are applied to the object as well if
requested.
Warning: The length of the freeze VIP cannot be changed. This is because the length is set
by the object to which the "object freeze" or "glue objects" function was applied.
Unfreeze object
This menu item removes the wave file created during "Object freeze" and brings back the
original object with all its settings that were saved in the temporary trackbouncing VIP.
Warning: Do not create any more new tracks in the freeze VIP as using the "Object
unfreeze" function will no longer be possible.
Lock objects
Here you can protect objects from being moved inadvertently. When opening this function
the key symbol turns red in the lower portion of the object. If, according to the display
options, the key symbol is grayed out, the objects will be displayed with a crossed out
diagonal line instead.