11.0

154 MIXER
Solo/Monitor bus (in the "Hybrid Engine" only)
Use this bus to monitor tracks individually by pressing the corresponding solo buttons
without influencing the stereo sum signal. This can have an effect during mastering or live
mixing.
You can access the signal at two different positions:
PFL: PFL (pre-fader listen) intercepts the signal before the faders and effects, but after the
input gain.
AFL: AFL (after-fader listen) takes all panorama changes/fader movements into account
and influences the monitoring signal accordingly.
To set up an AFL/PFL monitoring line, switch the button to AFL or PFL by clicking it, and
then select an output in the slot under your sound card as a solo bus.
Global solo modes
You can use the solo bus selection to set the global presets for using solo. This can also
be accessed by right-clicking on the solo buttons.
Global: Solo is not explicitly listed as a mode. It is activated if you don't check off any of
the listed solo modes and you will hear channels switched to solo without the AUX return
channels which feed them.
Global: Solo Safe mode has the effect that in Solo In Place mode, every channel switched
to solo will be automatically heard with the AUX return channels that feed it.
Global: Solo PLF (available only in hybrid mode) switches solo tracks to PLF mode. The
signal is tapped before the fader and effects, but after the input gain. In deactivated state,
the solo track are tapped after the fader.
Note: Economy tracks cannot be monitored with PFL.