Manualshelf

11.0

ManualsBrandsMagix Xara ManualsApplicationsSamplitude
141142143144145146147148149150
Table Of Contents
144 MIXER
increased until the key is again released or the end of the scale has been reached.
(Keyboard shortcut: Page down)
The level faders can be adjusted very precisely. If you click on these, keep the mouse
button pressed, move the mouse pointer away from the fader to the left or right. You can
then adjust the settings by moving the mouse in a vertical direction. The steps of the
settings become smaller as the mouse button is moved further away from the selected
fader.
The step size of the fader movement also becomes smaller if you keep “Shift” depressed
while moving a fader.
Knobs can be set in two different ways. After clicking on a knob, you can either move the
mouse around the knob – this corresponds to the preset – or move the mouse up an
down like with a fader. It is possible to make the settings steps smaller by holding down
"Shift". How the knobs are controlled can be set in the "System/Options" dialog (shortcut:
"Y") under "Keyboard, menu & mouse -> Mouse".
New AUX bus in mixer: A newly added AUX bus is always displayed in the arranger at the
bottom and in the mixer to the right with the highest channel.
Drag & drop in mixer: You can rearrange individual channel strips in the track number box
or name box via drag & drop. The mouse pointer turns into a hand. The overall settings of a
channel can be transferred to another channel via dragging & dropping the "FX" button.
The EQ settings can be transferred by dragging & dropping the "EQ" button.
The plug-in slots offer drag & drop functionality to copy effects to a different track or
between tracks and the master. The effects sequence for VST and DX plug-ins can be
changed within the track via drag & drop.
Note: If a certain effect is already available, a repeat drag and drop of the same effect onto
the same track performs a reset of the effect to the values of used effect, and does not
copy it; the original values will be overwritten.
If all you want to do is move effects between the channels in the mixer instead of copying
them, simply keep "Shift" pressed while dragging & dropping.