11.5

476 General settings
www.magix.com
1. Press the "Select controller" button. Then select your controller or a
compatible model from the list. With Delete or "Del" you can remove
selected controllers again. You can use the mouse to change the order of
the controllers and their internal assignment. A controller that is indented
corresponds to an expansion module. You can use the check box above
the controller or the "Activate controller" button to temporarily deactivate a
controller.
2. On the right you can select the MIDI parts that are connected to your
controller.
3. Your controller is ready for action after you have closed the dialog.
Track number
Specifies the number of tracks in a bank available to the controller. These are
usually 8 tracks. Mackie Control and HUI Protocol can only access 8 channels
per bank. However, there are also controllers that have a native mode letting
you learn several channels. Here you can set this value to 16 or 24 (max. 64).
The value is set to "1" for single-track controllers.
Ignore SysEx input data
SysEx data sent by the controller is not processed by Samplitude 11.5
Producer.
Hardware controller – "Internal" mode
The internal modes are used to adjust to different hardware controllers that
operate differently. Depending on the mode, the controller display is addressed
differently and Samplitude 11.5 Producer interprets the controller messages
correspondingly.
Hint: If you are using a controller which is different than the one listed here,
then you should select one from the list that is similar to yours in concept and
design.
Internal modes description:
Mackie Multitrack
Track
Press first time: Track mode
Press second time: Active control mode